TS1258 Pressure Tank
Techcon Systems TS1258 pressure reservoir or tank is designed to accommodate fluids that are supplied in bottle or container form. Constant air pressure forces the fluid from the bottle through pre-installed tubing up to the point of dispense. Black fluid tubing is available for UV applications. Compression fittings are used on the lid of the pressure reservoir or tank to ensure a continuous fluid path to the dispensing valve. Air-tight seals ensure there are no leak points or air entrapment problems and that fluid touches nothing but tubing from pressure reservoir or tank to the dispensing valve. Disposable polyethylene fluid lines can be changed quickly and easily. Optional fluid line kits include top and bottom ferules, compression fitting, black and clear fluid lines (no clear fluid line supplied with TS1252-4MM).
TS1254 Pressure Tank / Reservoir
The new medium size TS1254 pressure tank is designed to accommodate low to medium viscosity fluids, including solvents, adhesives, as well as Cyanoacrylate (CA). Equip with pressure relief (safety) valve and couple with stainless steel chamber, the TS1254 provides safe and secure dispensing for all applications. Airtight lid seal ensures there are no leak points for air or material.
The material feed line is located in the center of the lid to allow direct and continuous feed path from the material container to the valve inlet. The TS1254 is supplied with ¼" (6mm) Teflon tubing to provide resistant to all types of dispensing fluids. An optional 4mm tubing kit (TS1252-4MM) is available.
TS1212 Disposable Pinch Tube Valves
Disposable Pinch Tube Valves provide control for continuous or micro shot applications of low to semi-viscous fluids. The TS1212 semi-automatic version relies on a dispensing controller sending a pre-programmed air signal that opens the valve and allows fluid to flow. Once the dispense cycle is complete, the air signal stops and the internal spring forces the shut-off piston to "pinch" the disposable feed path, preventing further fluid flow.
The only part of the valve making contact with the fluid being dispensed is the disposable pinch tube assembly making the TS1212 ideally suited to dispensing 2-part and CA (Cyanoacrylate) materials.
Recommended Controller: TS500R, TS350, TS250 in conjunction with TS1258
Features
• Disposable feed path – no cleaning required
• Optional black feed paths for UV fluid applications
• Optional polyurethane feed paths available
• Simple to operate
• Compact size and weight